Commissioning; Wall Mounting; Registration / Programming; Automatic Registration - Disty distybox 300 Bedienungsanleitung

Commissioning

Mounting
Selecting a distybox
The is designed for wall mounting in
300
suitable location interior rooms.
Please note that the device must not be fitted in the immediate
NOTE
vicinity of any other electronic devices such as hifi systems, office
machines or microwave ovens. This prevents any interference
between the devices. In addition, the device should not be installed
near heat sources (e.g. radiators or in direct sunlight).
To prevent noise interference when making calls, the connected
terminal should not be positioned closer than one metre away from
distybox
the .
300
distybox
The must be able to establish a radio link to the DECT
300
Radio base station. Before determining the final mounting position, you
coverage should therefore check that your desired location is within the range
of the DECT base station. Owing to the digital transmission in the
frequency range used, there may be radiowave "blind spots" even
within the specified range, depending on the nature of the building.
This results in a loss of transmission quality. However, just a small
change in position will restore normal transmission quality. As the
distybox works as a cordless unit on your DECT base station,
300
you can use your cordless handset to check whether or not the
mounting position is suitable.

Wall mounting

Follow the steps given below to install the
1. Drill two 6 mm diameter holes into the wall at a distance of 60
mm apart.
2. Insert the rawl plug and turn the screws until
they are approx. 5 mm away from the wall.
3. Connect your terminal to the
distybox
4. Connect the
distybox
5. Fit in place.
300
22
distybox
300
distybox
.
300
60 m
to the power supply.
300
Operating Instructions

Registration / programming

The distybox must be registered on your DECT/GAP base
300
station before it can be used. The registration process can normally
be carried out using the "Automatic registration" function.
"Programming mode" allows you to set various parameters to
modify the distybox
Additional parameters allow the distybox to be set according to
your personal preferences. Manual registration can also be carried
out in this mode.

Automatic registration

The distybox can be registered automatically, assuming it has
300
not been registered on any other base station yet. To do this, the
PIN on your base station must be set to "0000" or "1111".
1. Connect the power supply unit (adapter) to your
2. Connect your telephone to the
handset on the hook.
3. Ensure that your base station enables an additional cordless
phone to be registered.
4. During the registration process, the
located close to your base station.
5. Start the registration procedure for the device on your
DECT/GAP base station as if you were registering an
additional cordless unit. Instructions on how to do this will be
given in the operating manual for your base station.
6. Plug the power supply unit into a power socket. The
registration process will be started automatically.
7. The registration process has been successful if the LED flashes
at intervals of approx. 10 seconds.
NOTE
If the registration process has not been completed successfully
within approx. 3 minutes, register the device manually in
programming mode.
Operating Instructions
distybox
to suit the functionality of your base station.
300
distybox
distybox , leaving the
300
distybox should be
300
300
.
300
23