U.S. Robotics 9106 Kurzanleitung Seite 6

Modem Installation
Step 1. Connect Microfilters (if included or required by
your ISP)
Your ISP will determine if microfilters are necessary. If microfilters were not
included, check with your ISP to determine if microfilters are needed.
To install the microfilter, plug the phone into the microfilter, and then plug the
microfilter into the telephone wall jack. Do not install a microfilter on the cable
that connects your gateway to the telephone jack unless your microfilter has a
connection for both the telephone and the ADSL device.
Step 2. Setting Up Your Computer for Installation (Macin-
tosh and Linux users skip to Step 3)
Before you plug the gateway into the computer, you must first install the
software. Make sure that your computer is on. You should have your operating
system CD-ROM readily available.
1. Insert the Installation CD-ROM into your computer's CD-ROM drive. The
installation will start automatically. This process may take a moment.
In the event the installation does not start automatically, click Windows
Start and then Run. Type D:\setup.exe in the dialogue box and click OK. (If
your CD-ROM drive uses a different letter, type that letter in place of D.)
4
4