U.S. Robotics 9106 Kurzanleitung Seite 11

The default settings are as follows:
Wireless Status = Enabled
Access Point = SSID Broadcast Enabled
WEP Encryption = Disabled
If you want to change these parameters, click Configure Wireless. A Web
browser will launch momentarily. It is recommended that you enable WEP and
assign a security secret key. Make sure you assign the same secret key to your
wireless devices to ensure future connectivity. To further guarantee wireless
security, enable the Mac Filter options on the Wireless - Mac Filter web user
interface screen. For more information about this and additional wireless
parameters, refer to the User Guide located on the Installation CD-ROM.
If you have any difficulties connecting to the U.S. Robotics
Wireless Gateway, check the following top three issues and see if they apply to
your situation.
• If you are attempting to create a wireless connection but cannot connect to
SureConnect
the U.S. Robotics
wireless card is set to Infrastructure mode. If the wireless cards are set to
802.11b AdHoc mode, you will not be able to connect to the U.S. Robotics
SureConnect
ADSL Wireless Gateway. When each wireless card is set to
Infrastructure mode, it should automatically connect to the Access Point of
the U.S. Robotics SureConnect
cards do not automatically connect, rescan until they detect the U.S.
SureConnect
Robotics
• If you create a wireless connection to the U.S. Robotics
Wireless Gateway but are experiencing poor link quality, check the posi-
tioning of the U.S. Robotics
tances, multiple floors, or steel or concrete walls can diminish the link
quality. If possible, reposition the U.S. Robotics
less Gateway to reduce the effect of any of these obstacles.
ADSL Wireless Gateway, make sure each
ADSL Wireless Gateway. If the wireless
ADSL Wireless Gateway and connect.
SureConnect
ADSL Wireless Gateway. Long dis-
SureConnect
9
SureConnect
ADSL
SureConnect ADSL
ADSL Wire-
9