Levelling The Refrigerator - Samsung Seag Swiss RS 7 Series Handbuch

LEVELLING THE REFRIGERATOR

Now that the doors are back on the refrigerator, you
will want to make sure the refrigerator is level so you
can then make fi nal adjustments. If the refrigerator
is not level, it will not be possible to get the doors
perfectly even.
The front of the refrigerator is also adjustable.
When the Freezer door is lower than
the fridge
Insert a fl at-blade screwdriver into a notch on the
Leg, turn it clockwise or counter clockwise to level
the freezer.
Screw Driver
When the Freezer door is higher than
the fridge
Insert a fl at-blade screwdriver into a notch on the
Leg, turn it clockwise or counter clockwise to level
the fridge.
Refer to the next section for the best way to
make very minor adjustments to the doors.
DA68-02710R(0.1).indb Sec4:11 DA68-02710R(0.1).indb Sec4:11
Downloaded from www.Manualslib.com
Leg
Leg
Screw Driver
manuals search engine
MAKING MINOR ADJUSTMENTS
TO THE DOORS
Remember, a level refrigerator is necessary for getting
the doors perfectly even. If you need help, review the
previous section on levelling the refrigerator.
When the door of the freezer
is higher than the fridge
In the process for adjusting both the doors is the
same. Open the doors and adjust them, one at a
time, as follows:
1. Unscrew the
nut 1 from the
lower hinge until
it reaches the
upper end of the
2
bolt .
When you release the nut
you use the Allen wrench provided
2
the bolt in a counter-clockwise direction.
You should then be able to unscrew the nut
with your fi ngers.
2. Adjust the
height difference
between the
doors by turning
the bolt 2
clockwise
or counter clockwise
When you turn clockwise
move up.
3. After adjusting
the doors, turn
the nut 1
clockwise
until it reaches
the lower end
of the bolt, then
tighten the bolt again with the wrench
the nut in place 1 .
If you do not secure the nut fi rmly, the bolt may
release.
Adjustment
part
3
Wrench
2
Bolt
1
Nut
1 , make sure that
3
to loosen
1
3
Wrench
2
Bolt
.
, the door will
3
Wrench
2
Bolt
1
Nut
3
to fi x
_11
setting up
2012.6.21 1:43:54 PM 2012.6.21 1:43:54 PM