Samsung Seag Swiss RS 7 Series Handbuch Seite 14

INSTALLING THE WATER
DISPENSER LINE
For Exterior model
Parts for water line Installation
Water line fi xer and screws
Connecting to the water supply line
Connect the water pipe with coupler and tap.
1. Close the main water tap.
2. Connect coupler "A" to the tap.
The water line must be connected to the cold
water pipe. If it is connected to the hot water
pipe, it may cause the purifi er to malfunction.
WARRANTY INFORMATION
This water line installation is not covered by the
refrigerator or ice maker manufacturer's warranty.
Follow these instructions carefully to minimise the risk of
expensive water damage.
Note:
If the coupler does not fi t on the current tap, go
the nearest authorized service dealer and purchase the
right couplers fi ttings.
select the location where the purifi er is to
install. (Model with the purifi er)
- If you wish to reassemble the water inlet and outlet
sides of the purifi er during purifi er installation, see
the reference illustration.
- Cut the water line attached to the purifi er to the
appropriate place after measuring the distance
between the purifi er and the cold water tap.
14_
setting up
DA68-02710R(0.1).indb Sec4:14 DA68-02710R(0.1).indb Sec4:14
Downloaded from www.Manualslib.com
Pipe connector
Water line Purifi er lock-clip
CAUTION
manuals search engine
SIDE OF
PURIFIER
PURIFIER WATER
Purifi er
WATER INLET
SIDE OF PURIFIER
COUPLER "A"
TAP
LINE OUTLET
90 degree
CAUTION
Insert Locking Clip After Insert Locking Clip After
tube seated tube seated
COUPLER
Locking Clip Locking Clip
2012.6.21 1:44:1 PM 2012.6.21 1:44:1 PM