Normal Operation - Samsung Seag Swiss RS 7 Series Handbuch

CHECKING THE WATER
DISPENSER LINE (OPTIONAL)
A water dispenser is just one of the helpful features
on your new Samsung refrigerator. To help promote
better health, the Samsung water fi lter removes
unwanted particles from your water. However, it
does not sterilize or destroy microorganisms. You
will need to purchase a water purifying system to do
that. In order for the icemaker to operate properly,
water pressure of 138 ~862 kPa is required. Under
normal conditions, a 170 cc paper cup can be fi lled
in 10 seconds. If the refrigerator is installed in an area
with low water pressure (below 138 kPa), you can
install a booster pump to compensate for the low
pressure. Make sure the water storage tank inside
the refrigerator is properly fi lled. To do this, press the
water dispenser lever until the water runs from the
water outlet. When using the Water Dispenser, Slight
noises can be generated from supplying water.
Water Line installation Kits are included. You can
fi nd it in one of the freezer drawers.
USING THE ICE MAKER (OPTIONAL)
(RS77*)
To Remove the Ice Bucket
- Hold the handle as shown in fi gure1.
- Slightly pull up the bottom part.
- Take out the ice bucket slowly.
To Refi t The Ice Bucket
- Assemble it in the reverse
order of disassembly.
- Push the bucket in fi rmly until
you hear a clicking sound.
- When the bucket does not fi t
into its place, turn the gear
handle on its back by 90
degrees and reinstall it again
as shown in fi gure 2.

Normal Operation

- Any sounds you hear when the ice
maker dumps ice into the bucket
are part of normal operation.
- Not dispensing ice for long
periods may cause ice
clumps in the ice bucket.
Remove the remaining ice
and empty the bucket.
- When ice does not come out,
Check for any ice stuck in the
chute and remove it.
- The fi rst batch of ice cubes may
be small due to air in the pipe
after connection, any air will be
purged during normal use.
12_
setting up
DA68-02710R(0.1).indb Sec4:12 DA68-02710R(0.1).indb Sec4:12
Downloaded from www.Manualslib.com
Figure1
Figure2
Ice Chute Ice Chute
manuals search engine
- When ICE OFF blinks on the display panel,
reinsert the bucket and/or make sure it's
CAUTION
installed properly.
- When the door is open, the Ice and water
dispenser do not work.
- If you close the door hard, it may cause
water spilling over the ice maker.
- To prevent dropping the ice bucket, use
both hands when removing it.
- To prevent injury, be sure to clean up any
ice or water that may have dropped on
the fl oor.
- Do not let children hang on the ice dispenser
or on the bucket.
They may get hurt.
- Be sure not to put your hand or any object
into the ice chute.
It may cause personal injury or damage
mechanical parts.
Check the amount of water supplied
to the ice tray.
(RS757*/ RS756*)
1. Lift up the icemaker cover and gently pull out.
2. When you press the Test button for 3 seconds,
the ice cube container is fi lled with water from the
water supply tap. Check to make sure the amount
of water is correct (see the illustration below).
If the water level is too low, the ice cubes will be
small. This is a water pressure problem from with
in the main water pipes, not the refrigerator.
1
Ice maker
Feeler Arm
Check the water level
Test button
2
2012.6.21 1:43:57 PM 2012.6.21 1:43:57 PM