Samsung Seag Swiss RS 7 Series Handbuch Seite 10

Reattaching the Fridge Door
1. Insert the lower hinge
hinge bracket
2. Fit the hole in the corner of the fridge door
over the lower hinge
3. Insert the upper hinge shaft
on the hinge
between the upper hinge hole
the top of the cabinet
screws
in a clock wise direction.
4. Place the front part of the upper hinge cover
on the front of the upper hinge
with the screw.
11
10_
setting up
DA68-02710R(0.1).indb Sec4:10 DA68-02710R(0.1).indb Sec4:10
Downloaded from www.Manualslib.com
back into the lower
1
2 .
.
4
3
4
5 into the hole
. Make sure the hinge is level
6
and the hole on
7
8 . Then, reattach hinge
and the ground screw
9
10
and reattach it
12
manuals search engine
Reattaching the Water Supply Line
1. Insert the water line
1
2
3
2. The Water Line must be fully Inserted to the center
of transparent coupler to prevent water leakage
from the dispenser.
3. Insert the 2 clips in the install pack and check that
each clip holds the line fi rmly.
by turning it
Do not cut the water line.
Gently separate it from the coupler.
Reattaching the Front Leg Cover
Before attaching the cover, check water
connector for leakage.
Replace the front leg cover by turning the three
screws clockwise, as shown in the fi gure.
11
12
2 .
1
into the coupler
1
2
Center of transparent Center of transparent
coupler coupler
clip A (1/4 in.) clip A (1/4 in.)
(6.35 mm) (6.35 mm)
2012.6.21 1:43:51 PM 2012.6.21 1:43:51 PM