Samsung Seag Swiss RS 7 Series Handbuch Seite 21

3. Next, remove the fi xed cap by turning it counter
clockwise.
4. Remove the new fi lter's protective cap and
remove the old fi lter.
5. Position and insert the new fi lter into the fi lter
housing. Slowly turn the water fi lter clockwise
90º to align with the indication mark on the cover,
locking the fi lter in position. Make sure that the
indicator is lined up with the "lock" position. Do
not over tighten.
1
Sticker
(month
indicator)
For Exterior model
1. Shut off water supply.
2. Note the Flow direction on the fi lter.
3. Insert water supply tube into the inlet side of the
fi lter until the tube stop.
WATER SUPPLY
INLET SIDE
4. After inserting tube, put together the clip strongly.
The Clip fi x the tube.
5. Turn on the water and check for leaks. If leaks
occur, repeat step 1,2,3,4. If leaks persist,
discontinue use and call your supporting dealer.
6. Once you have completed this process, hold the
Ice Type button for 3 seconds to reset the fi lter
schedule.
DA68-02710R(0.1).indb 섹션2:21 DA68-02710R(0.1).indb 섹션2:21
Downloaded from www.Manualslib.com
2
4
3
FLOW DIRECTION
Note :
You must also ensure
that the cut is square
and not at any sort
of angle as this could
cause a leak
manuals search engine
7. Lastly, Dispense 1 L of water through water
dispenser and throw away. Make sure that water
fl ows clearly again before drinking.
A newly installed water fi lter cartridge may
cause water to briefl y spurt from the water
Cover fi lter
dispenser. This is due to air getting into the line.
It should pose no problem to operation.
Ordering replacement fi lters
Align the
indication To order more water fi lter cartridges, contact your
mark with
5
lock position
authorized Samsung dealer.
- Internal Filter - HAFIN2/EXP
- External Filter - HAFEX/EXP
PERMEAT
_21
operating
2012.6.21 1:44:15 PM 2012.6.21 1:44:15 PM