Makita DF012D Betriebsanleitung Seite 7

Adjusting the fastening torque
► Fig.5: 1. Adjusting ring 2. Graduation 3. Arrow
The fastening torque can be adjusted in 22 levels by turning the adjusting ring. Align the graduations with the arrow
on the tool body. You can get the minimum fastening torque at 1 and maximum torque at
The clutch will slip at various torque levels when set at the number 1 to 21. The clutch does not work at
the marking.
Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which
torque level is required for a particular application.
NOTE: See the following chart for the relation between the number of torque setting and fastening torque rate.
The fastening torque rate will be different depends on materials. Make a test fastening to get the desired torque
before operation.
Guideline for clutch auto stop
Work range of clutch auto-stop
High
-
-
-
-
-
When driving machine screws
Lighting up the front lamp
CAUTION:
Do not look in the light or see the
source of light directly.
To turn on the light, slide the lamp switch to the A position.
To turn off the light, slide the lamp switch to B position.
Even if you leave the lamp on, the light will automati-
cally turn off after 5 minutes.
► Fig.6: 1. Lamp switch 2. Lamp
NOTE: The lamp signals by flickering during use
when the battery power is almost used up.
At this time, recharge the battery or replace the bat-
tery with a fully charged one.
Increments on adjusting ring
for fastening torque
Low
-
-
Increments
1 - 3
4 - 8
9 - 18
19 - 21
ASSEMBLY
CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
socket bit
► Fig.7
Use only driver bit/socket bit that has inserting portion
shown in the figure. Do not use any other driver bit/
socket bit.
7 ENGLISH
marking.
Fastening torque
1 Approx. 0.3 N•m
(Approx. 3 Kgf•cm)
5 Approx. 0.82 N•m
(Approx. 8.4 Kgf•cm)
9 Approx. 1.35 N•m
(Approx. 13.8 Kgf•cm)
13 Approx. 1.88 N•m
(Approx. 19.2 Kgf•cm)
17 Approx. 2.41N•m
(Approx. 24.6 Kgf•cm)
21 Approx. 2.9 N•m
(Approx. 30 Kgf•cm)
At low speed, approx. 8 N•m
(Approx. 81.6 Kgf•cm)
At high speed, approx. 1.5 N•m
(Approx. 14.7 Kgf•cm)
Guideline for machine screw diameter
2.5 mm
3 mm
4 mm
5 mm
Always be sure that the tool is