Description Of Terminals - urmet domus GENYA 2GO! Bedienungsanleitung

OPTIONAL PROGRAMMING FOR ADDITIONAL FUNCTIONS
The following programming operations are needed after testing the basic operation of the system only if the
following functions are required:
DOOR UNIT FREE DOOR OPENER FUNCTION
This function is typically used for secondary stations.
To program a secondary door unit in free door opener mode, defi ne the last of the column users who can
open the door by pressing the door lock button without having established a voice connection beforehand.
The column is defi ned by the sequence of codes in the range from CODE and the code set during
programming stage (last column user code).
1. Set the dip switch ID to 0 to start programming. The door unit will beep every fi ve seconds to indicate
that programming is in progress and the yellow LED will be on.
2. Press the last panel button connected to the door unit briefl y (button of the last column user). The door
unit will beep to confi rm programming.
Release the button immediately.
3. Reposition the ID dip switches in the correct setting. The yellow LED will go out.
SURVEILLANCE CAMERAS AUTO-ON FUNCTION
Program the function on the Master station if surveillance cameras are present.
1. Set the dip switch ID to 0 to start programming. The door unit will beep every fi ve seconds to indicate
programming state and the yellow LED will be on.
2. Press the hall button (PA-GND) briefl y. The module will beep once to indicate that the function has been
programmed.
3. Reposition the ID dip switches in the correct setting. The yellow LED will go out.
Repeat the procedures from step 1 to 3 to deactivate the function. The module will beep in sequence
to indicate that the function has been deactivated.
14
ID
ID=0
ID
ID=0
LED COLOUR
1. Press the button to program the LED colours.
2. Press button 2 to scroll the colour palette. Press button 1 to go back to palette
There are 37 available colours are proposed as follows: light with colours traditionally used for panels
(emerald green, blue, amber, light green), switch-off, 33 customised colour lights. The LEDs will go out
at the end of the sequence. Press button 2 again to repeat the sequence from the beginning.
3. After selecting the colour, press the programming button to end the colour selection procedure.
INDICATIONS
White-yellow blinking LED:

DESCRIPTION OF TERMINALS

LINE Terminal pair for connecting non-polarised bus
V3 Composite video signal
V5 Video signal ground
T 1038/69 relay box connection for surveillance camera cycle function
PA Hall button connection
SP Door open sensor connection
GND 2 reference terminals for PA, SP, T terminals
SE- Electrical lock connection (negative)
SE+ Electrical lock terminal (positive
~0 }
Terminal pair for lighting button name holder tags
~12
DS1082-017B DS1082-017B
Button 1
LED colour programming button
Button 2
busy line or no data line.
selection.
15