Advice On Disposal; Troubleshooting - Bosch Sensixx B45L Gebrauchsanleitung

en

Advice on disposal

Our goods come in optimised packaging. This basically
consists in using non-contaminating materials which
should be handed over to the local waste disposal
service as secondary raw materials. Your local town
council can give you information about how to dispose
of obsolete appliances.
This appliance is labelled in accordance
with European Directive 2002/96/EG
concerning used electrical and electronic
appliances (waste
electronic equipment - WEEE).
The guideline determines the framework
for the return and recycling of used
appliances as applicable throughout the EU.
Trouble shooting
Problem Possible causes
Pilot light (11) flashes Boiler and filter must be rinsed.
The steam generator • There is a connection problem.
does not come on. • The main power button is not
The iron does not • The main power button is not
heat up.
• The temperature is set to a low
The iron begins to • During first use: certain components
smoke when switched
on.
• During subsequent use: the
Water flows through • The steam function is being used
the holes on the
soleplate.
• The water is condensing inside the
Dirt comes out • There is a build up of scale or
through the soleplate.
• Chemical products or additives have
14
electrical and
switched on.
switched on.
position.
on the appliance have been lightly
greased at the factory and may
produce a little smoke when initially
heated.
soleplate may be soiled.
before it has reached the correct
temperature.
pipes because steam is being used
for the first time or has not been
used for a long time.
minerals in the steam tank.
been used.
Tips to help you save energy
Steam production consumes the most energy. To help
minimise the energy used, follow the advice below:
• Start by ironing the fabrics that require the lowest
ironing temperature.
Check the recommended ironing temperature in the
label on the garment.
• Regulate the steam according to the selected
ironing temperature, following the instructions in this
manual.
• Try to Iron the fabrics while they are still damp and
reduce the steam setting. Steam will be generated
from the fabrics rather than the iron. If you tumble dry
your fabrics before ironing them, set the tumble drier
on the 'iron dry' programme.
• If the fabrics are damp enough, turn off the steam
regulator completely.
Solution
Rinse the filter and the boiler according to
the cleaning instructions in this manual (see
section E).
• Check the mains cable (6), the plug and
the socket.
• Set the main power button (12) to the "I"
position (illuminated in red).
• Set the main power button (12) to the "I"
position (illuminated in red).
• Set the temperature to the desired
position.
• This is completely normal and will stop
after a short while.
• Clean the soleplate according to the
cleaning instructions in this manual.
• Reduce the steam flow when ironing at
low temperatures.
• Point the iron away from the ironing area
and press the steam release button until
steam is produced.
• Use tap water mixed 50% with distilled
or demineralised water. To prolong the
optimum steam function, mix tap water
with distilled water 1:1. If the tap water in
your district is very hard, mix tap water
with distilled water 1:2.
• Clean the soleplate with a damp cloth.
• Never add products to the water.