Einige Zusatzinformationen zur Schaltungs- Additional Information on the M 149 Tube legendären Mikrofonen U 47 und M 49 bekannt M 49 microphones (“M 7 capsule”). The M 149 Tube technik im M 149 Tube Circuit Design und berühmt geworden ist („M 7-Kapsel“). Das can be switched to nine diff...
M 149 Tube Damit bestimmen ausschließlich diese Glieder The head grille of the M 149 Tube has the same nung, die über einen Regelkreis im Netzgerät kons- microphone and the power supply unit – are de- die Klangeigenschaften des Mikrofons und nicht shape as that of the M 49, but it is acoustically tant gehalten wird.
2.4 Mikrofonkabel 2.4 Microphone Cables sung beeinträchtigt die Funktion des M 149 Tube tract from the performance of the M 149 Tube. If Für das M 149 Tube stehen folgende Kabel zur The following cables are available for the nicht. Wird eine externe Phantomspeisung an- an external phantom power source is switched on Verfügung:...
Seite 5
M 149 Tube Pin 2 ist also die „heiße Phase“, und Pin 3 muss für So pin 2 is the “hot phase”, pin 3 must be con- Technische Daten Technical Specifi cations unsymmetrische Eingänge an Masse gelegt werden nected to ground when used with unbalanced in- Akustische Arbeitsweise ..
M 149 Tube Frequenzgänge und Polardiagramme Frequency Responses and Polar Patterns gemessen im freien Schallfeld nach IEC 60268-4, Toleranz ±2 dB measured in free-fi eld conditions (IEC 60268-4), tolerance ±2 dB...
Membran particularly to be recommended for microphones M 149 Tube vorgesehen. Der schwenkbare Gewin- M 149 Tube microphones. It has a swivel mount eingebrannte Nikotinschicht. Insbesondere bei which are rented or are used in dusty or smoky en- deanschluss hat 5/8"-27-Gang, mit Adapter für...
Seite 8
M 149 Tube Mikrofonneigevorrichtungen Auditorium Hangers MNV 87 ....ni ....Best.-Nr. 06804 MNV 87 ....ni ....Cat. No. 06804 MNV 87 mt .... sw ..... Best.-Nr. 06806 MNV 87 mt .... blk ....Cat. No. 06806 Die Neigevorrichtung besteht aus einer Kabelhal- The auditorium hanger consists of a cable suspen- terung und einem drehbaren 1/2"-Gewindezapfen...
Seite 9
Limitation of Liability Declaration of Conformity Georg Neumann GmbH shall not be liable for consequences of an inappro- Georg Neumann GmbH hereby declares that this device conforms to priate use of the product not being in compliance with the technical allow- the applicable CE standards and regulations.