Troubleshooting - Eibenstock PLD 450 B Originalbetriebsanleitung

The declared vibration emission level represents the main applications of
the tool. However if the tool is used for different applications, with different
accessories or poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total working period.
An estimation of the level of exposure to vibration should also take into
account the times when the tool is switched off or when it is running but not
actually doing the job. This may significantly reduce the exposure level over
the total working period.
Identify additional safety measures to protect the operator from the effects
of vibration such as: maintain the tool and the accessories, keep the hands
warm, organisation of work patterns.
In Case of Malfunction
In case of breakdown, switch the machine off and
disconnect the plug from the mains. Repairs on the
electric parts of the tool may only be done by an electric
specialist.
Trouble Shooting
Error
machine does not
work
motor runs, drill bit
does not rotate
drilling speed too
slow
motor cuts off
water drops out of
the gearbox housing
Possible Cause
mains current supply interrupted
line cord or plug damaged
switch damaged
the PRCD-switch is off
gearbox damaged
water pressure / water flow rate
too high
drill bit damaged
gearbox damaged
drill bit is blunt
the tool stops
overload protection of the motor
has reacted
shaft sealing rings damaged
Error Recovery
plug in another electric
appliance and check the
functioning
have it checked by an electric
specialist and replaced if
necessary
have it checked by an electric
specialist and replaced if
necessary
press RESET to switch on
have the tool repaired by an
authorised service workshop
regulate the water quantity
check if drill bit is damaged and
replace it if necessary
have the tool repaired by an
authorised service workshop
sharpen the drill bit with a
sharpening block while using
the flush
lead the tool in a straight
manner discharge the tool and
restart it by pressing the switch
have the tool repaired by an
authorised service workshop
28