Technical Data; Declaration Of Conformity; Safety Instructions - WOLFF 020727 Originalbetriebsanleitung

1.0 Technical data

Power supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .230V AC
Power consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . .2000W
Speed (No-load operat) . . . . . . . . . . . . . . . . . . . . . .8500 U/min
Sound pressure level . . . . . . . . . . . . . . . . . . . . . . . . . .94 dB(A)
Sound energy level . . . . . . . . . . . . . . . . . . . . . . . . . .107 dB(A)
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .23 kg
Grooving thickness . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6mm
Grooving blade . . . . . . . . . .tungsten tipped, Ø 125 x Ø 22 x 6
Width of wall cove base . . . . . . . . . . . . . . . . . . . . . .7,5 .. 33cm
2.0

Declaration of Conformity

We declare under our sole responsibility that this product is in con-
formity with the following standards of standardization documents:
DIN EN 1037, EN ISO 12100, DIN EN 60204-1, DIN EN 60745-1,
DIN EN 60745-2-5, DIN EN 55014-1, DIN EN 55014-2:
according to the provisions of the: 2006/42/EC, 2004/108/EC,
2006/95/EC.
Dipl.-Ing. (FH) Dieter Hammel
Authorised to issue this declaration and for the gathering
of the technical documentation.
10.02.2015 i.V.
WOLFF GmbH & Co. KG | D-74360 Ilsfeld | Ungerhalde 1

3.0 Safety instructions

Disconnect power supply before doing any maintenance at the
machine. Use only faultless sharpened blades that are appropriate
for your application. Maintenance only by qualified personnel.
Use only genuine spare parts. Every machine comes with
goggles and ear protection. Please use them for your own safety!
3.1 Introduction
This operating manual helps you to become familiar with the
Bench-miller for your maximum benefit. You get helpful information
to realize and avoid danger.
Thus you do not only improve your own safety, but decrease
repair costs and extend the durability of your machine.
This operating manual must be read in any case before starting
work with the Bench-miller. Also maintenance personnel must
have read and understood the instructions.
3.2 Danger while working with the machine
The Bench-Miller is designed to the highest technical standards.
Disturbances that could impair safety, have to be eliminated at once.
3.3 Restriction of use
The Bench-miller is designed exclusively for grooving of wall
cove bases in dry rooms. Any other or comprehensive usage is
not according the defined application. Wolff cannot be held res-
ponsible for any damage or loss caused by incorrect use.
03/2008
Comes with:
Bench-miller,
Pin-type face spanner,
Fork wrench, SW 8, SW 10
Socket wrench SW 4
Goggles,
Ear protection,
Operating manual
Always wear ear protectors and goggles! Using this
machine without ear protectors or goggles may jeopar-
dize or harm your health. It may harm especially your
ears resp. your eyes and increase the risk of an accident.
Use this machine only:
for the defined application
in a technically perfect condition
9