Designated Use - Endress+Hauser Levelflex FMP5 Serie Einbauanleitung

I/O module

Designated use

The spare part set and Installation Instruction are used to replace a faulty unit with a functioning unit of the same type.
Use genuine parts from Endress+Hauser only.
Only original spare part sets, intended by Endress+Hauser for the measuring device, shall be used. 
The verification has to be done via Online Support, this procedure is explained below.
For some devices there is an overview of the correct spare part set inside the connection compartment cover.
If the spare part is listed there, the verification is not required.
www.endress.com/support
1.
Device specific information
2.
3.
Ser. No.:12345
Authorized personnel to carry out repairs
Authorization to carry out a repair depends on the version of spare part set. The table shows the respective group of persons for each.
The person who carries out the repair is responsible for safety during the work, the quality of work completed and safety of the device
after repair.
Version of spare part set
I/O module: 2- wire
I/O module: 4-wire
1 = Trained customer technician, 2 = Service technician authorized by Endress+Hauser, 3 = Endress+Hauser (send measuring device back to manufacturer)
2
4.
=
?
5.
www.endress.com/support
Choose device specific information.
Enter the serial number (Ser. No.), search for product data and click on
"spare parts".
Display of all suitable spare parts.
Check the order number of the spare part.
Does the order number of spare part correspond to the order number in
the spare part list?
YES, the spare part can be used.
NO, the spare part may not be used.
Group of persons authorized to carry out repairs
1, 2, 3
1*, 2, 3
Endress + Hauser