Technical Specifications - Power Craft 80036 Gebrauchsanweisung

INSTRUCTION MANUAL
Introduction
To get the most out of your new bench grinder,
please read through these instructions and
the attached safety regulations before use. We
recommend also that you save the instructions
in case you need to refer to them at a later date.

Technical specifications

Voltage/frequency:
Power rating:
Dry grinding stone:
No-load speed
Diameter
Hole diameter
Thickness:
Wet grinding stone:
No-load speed
Diameter
Hole diameter
Thickness:
Bench grinder parts
1. Water tank
2. Wet grinding stone
3. Protective shield
4. Spark screen
5. Dry grinding stone
6. Rest
7. Mounting holes
8. On/off button
ENGLISH
Special safety regulations
Always use the correct type of grinding stone for
the type of work to be performed.
Never use damaged stones.
Never use stones that are too big.
Never put your hands close to the working area
while the bench grinder is rotating. Never allow
hands or fingers holding the item to be worked to
230 V ~ 50 Hz
get close to the grinding stone while it is rotating.
Please note that both grinding stones rotate when
250W
the bench grinder is switched on!
Do not use both grinding stones at the same time.
2,950 rpm
Always keep the spindle and flanges that hold the
150 mm
grinding stones clean.
12.7 mm
Never allow the grinding stones to make contact
16 mm
with the item to be worked - or other objects -
when starting the bench grinder.
134 rpm Do not touch metal filings until they have cooled.
200 mm
Do not leave the bench grinder unattended until
the grinding stone has come to a complete stop.
20 mm
Please note that it takes a little while for the
40 mm
stone to come to a complete stop after you have
switched the machine off.
19