Technical Specifications - Power Craft 54843 Gebrauchsanweisung

INSTRUCTION MANUAL
Introduction
To get the most out of your new compressed air
tool, please read these instructions and the
attached safety regulations before use. Please also
save the instructions in case you need to refer to
them at a later date.

Technical specifications

Omdrejningstal:
Disc diameter:
Air consumption rate
Compressed air supply:
Special safety regulations
Never use compressed air tools in areas where
there is risk of fire or explosion.
Compressors and compressed air tools can be
dangerous if operated incorrectly. Always observe
the compressor manufacturer's safety instructions!
Always remember to drain the compressor tank of
water and to clean the air hose filter. Water and
contaminants in the compressed air can damage
tools.
Always be aware of the location of the hose.
Sudden changes in pressure in the hose can cause
it to move with sufficient force to knock over
people and objects, which can cause injury or
damage. Always ensure the hose does not lie in a
place where you could easily trip over it.
Excessive air pressure will wear out tools faster and
can cause dangerous situations.
Do not allow the compressed air hose to come into
contact with sharp edges, heat and oil.
Never lift or carry the compressed air tools by their
hose. Always grip the tool itself.
Check the air supply, all hoses, connections,
nipples and adapters and that clean air is being
supplied at the correct pressure before use. NEVER
use the air supply and tool if this is not the case!
ENGLISH
Never use any other pressurized gas sources, such
as oxygen or acetylene.
Always disconnect the air supply before removing
or switching tools or accessories.
Check that the tool is not activated before
connecting air hoses.
Always use a face mask and protective glasses when
using compressed air tools in dusty environments,
as these tools can raise dust.
11,000 RPM
Compressed air tools in use can generate noise
5.91 in
levels in excess of 85 dB(A). If this is the case,
30.38 gal/min
always use ear protectors.
90 PSI (6.2 bar)
Always maintain a firm grip on compressed air
tools during use, to avoid dropping the tool due
3/8" tubes
to sudden expected movements.
Disconnect the tool from its air hose when not in
use.
Compressed air supply specifications
Check that air pressure in the hose is 90 PSI (6.2
bar), and that the compressed air supply is
functioning correctly. If the hose is very long (over
8 metres), the pressure can be increased to
compensate for the length.
Use compressed air hoses with internal diameter of
3/8".
Connection
a. Eccentric sander
b. Compressed air hose
c. Connection
d. Oil reservoir
e. Pressure regulator
f.
g. Non return valve
Filter
11