Power Craft 80036 Gebrauchsanweisung Seite 21

INSTRUCTION MANUAL
Use hard dry grinding stones for soft metals and
soft dry grinding stones for hard metals.
Cool the item in water at regular intervals when
working for extended periods.
When grinding tools, never allow the metal to blue.
Replacing grinding stones
Grinding stones must be replaced when they have
worn more than 40 mm or if they become damaged.
Wet grinding stone
Empty the water tank by removing the plug (h)
on the underside of the tank. Make sure that the
water does not get into the motor! Remove the
water tank.
Loosen the nut (i) and remove the outer flange (f)
and the old wet grinding stone.
Clean the flanges (f and g).
ENGLISH
Attach the new wet grinding stone, fit the outer
flange and secure it with the nut.
Reattach the water tank and insert the plug.
Dry grinding stone
Remove the protective shield and the spark screen.
Loosen the nut (l) and remove the outer flange (k)
and the old dry grinding stone.
Clean the flanges (j and k).
Attach the new dry grinding stone, fit the outer
flange and secure it with the nut.
Replace the protective shield and the spark screen.
Start the bench grinder and let it run freely for
a few minutes to check that the stone is fitted
correctly.
21