Assembly And Preparation - Power Craft 80036 Gebrauchsanweisung

INSTRUCTION MANUAL
Never use the bench grinder without the spark
screen and rest fitted.
The rest and spark screen must always be adjusted,
so that they are a maximum of 2 mm from the
grinding stone.
Take care not to spill water on the motor when
filling the water tank.

Assembly and preparation

Secure the bench grinder to the workbench by
inserting suitable bolts through the mounting
holes (7). Check that the bench grinder is securely
attached and level. If required, a piece of soft
wood can be inserted between the bench grinder
and workbench during assembly to damp
vibrations.
Adjust the rest (6), so that it is a maximum of 2
mm from the dry grinding stone (5).
ENGLISH
Attach the spark screen (4) to the protective shield
by mounting the base of the screen (d) so that it is
a maximum of 2 mm from the dry grinding stone,
and securing it with the screw (c), nut washers and
the nut (a). Tilt the spark screen forward on its
hinge (b) and check that it is correctly positioned.
Insert the plug into the mains socket.
Grinding
For dry grinding: Adjust the rest as described
above.
For wet grinding: Fill the water tank (1) with
water until the water comes halfway up to the
centre of the wet grinding stone (2).
Switch the bench grinder on using the on/off
button (8) and allow the grinder to reach full
speed before beginning to work on the item.
Present the item to the stone slowly and evenly
and then gently increase the pressure against the
stone. Never present the item abruptly to the
stone, as this may cause the item to kick back
and damage the grinding stone or cause injury
to the user or other people.
Hold the item firmly with both hands to prevent it
getting stuck between the grinding stone and rest,
which can damage the stone.
Do not use the bench grinder for more than 30
minutes at a time. Allow the machine to cool down
before using it again.
Check the water level in the tank regularly and
refill with clean water.
Switch off the bench grinder after use.
Empty the water tank by removing the plug on
the underside of the tank. Make sure that the
water does not get into the motor!
General information on grinding
Use the dry grinding stone for rough grinding and
the wet grinding stone for fine grinding.
Never grind materials such as wood, plastic or very
soft metals (e.g. lead), as they can block the pores
of grinding stones, reducing their effectiveness.
20