AEG MRC 4141 P Bedienungsanleitung Seite 64

English
64
• Switch on the display light: To switch on the display light again permanently, press
any button briefly. Then keep button (8) pressed for approx. 3 seconds. The symbol
goes out.
Displaying diverse information
1. Switch the device to standby using the
2. Briefly press the Y-M-D / C-F button (10) repeatedly. The following information is
displayed in succession:
If the button is no longer pressed, the display will switch back to time after about 5 sec-
onds.
Toggling the display
The following can be shown alternatingly on the display:
1. In order to activate this function, use the
2. Keep the / button (7) pressed, until "
Switch off toggling: To switch off Auto Toggle, keep the
standby. " " appears briefly on the display.
NOTE:
Only the time is shown via the rotatable projector (16).
Toggle temperature display between °C (Celsius) and °F (Fahrenheit)
1. Switch the device to standby using the
2. Briefly press the Y-M-D / C-F button (10) repeatedly until the temperature is dis-
played.
3. While the temperature is displayed, press the
onds to switch between °C and °F.
Weather display (3)
The device does not just determine the room temperature and the humidity using the sen-
sor (22), but it can also create an approximate weather forecast for the next 12 to 24 hours.
However, the measurement can deviate from the actual weather conditions.
1. To do so, set up the device near an open window.
2. After about 3 hours, the device will have adjusted to the weather conditions.
button (5).
Year Date Temperature
Time Date Temperature
button (5).
Humidity
Humidity
button (5) to switch the device to standby.
" appears briefly on the display.
/ button pressed again in
Y-M-D / C-F button for about 3 sec-