AEG MRC 4141 P Bedienungsanleitung Seite 63

2. Insert one battery of the type CR2032, 3 V. Mind the correct polarity ( must be at the
top)!
3. Close the battery case. Secure the battery compartment lid again with the screw.
4. If the device is not used for an extended period of time, remove the Battery from the
device to avoid any leaking of battery acid.
WARNING:
The batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
Danger of explosion!
CAUTION:
Batteries are not to be disposed of together with domestic wastes. Dispose of the used
batteries at the relevant collection bin or at your dealer' s .
Power supply
• Make sure the grid voltage corresponds to the figures on the rating plate.
• Insert the grid plug into a properly installed power socket.
• If you have not inserted a backup battery, the stored clock time will be lost as soon as
the power supply is interrupted.
Switching the Unit On/Off
Press the button (5) to switch the unit on or off.
Volume
Adjust the volume with the / (7) and
Display Brightness
Use the SNOOZE/SLEEP / DIMMER button (1) to adjust the display brightness.
Turn off display light
If you are disturbed by even the lowest brightness setting of the light, you can turn it off.
• In standby, keep the button (8) pressed for approx. 3 seconds. The symbol (14) will
appear beside the display. The display light turns off after approx. 15 seconds.
NOTE:
Press any button to switch on the brightness again for 15 seconds.
(8).
English
63