AEG Electrolux SANTO S80408-KG8 Gebrauchsanweisung Seite 39

Symptom
Appliance cools too much.
In the display, "POWER" is
displayed.
Temperature display shows
a square or a letter. In the
display, "SERVICE" is dis-
played.
Alarm sounds, red back
lighting flashes.
"TEMPERATURE" is flashing
in the display.
An alarm sound is
sounding. In the display
"DOOR OPEN" and a red
back light are flashing.
Interior illumination does
not function.
Water on the floor or on
storage shelves.
Heavy build up of frost,
possibly also on the door
seal.
The compressor does not
start immediately after
changing the temperature
setting or the operating
mode.
818 42 32-00/0
Possible Cause
Temperature is set too cold.
There was a power failure.
There is a function fault.
Temperature warning for
freezer section or fridge
section.
Freezer section door and/or
fridge section door open
for too long.
Light bulb is defective.
Important: The interior
lighting switches off auto-
matically after 7 minutes.
Water drain hole is
blocked.
Door seal is not air tight
(possibly after changing
over the hinges).
This is normal, no error has
occurred.
What to do if ...
Solution
Temporarily select a higher
temperature setting.
Please check whether the
power plug is plugged in or
whether the fuse has been
tripped (see also section
"Control and information
system"). Check the status
of the food.
Please inform customer
service. Do not open the
doors of the appliance
again.
Please check in "Control
and Information System"
section.
Please look at the section
"Control and information
system". Do not leave the
doors open longer than
necessary.
Please refer to "Replacing
the Light Bulb" section.
See the "Maintenance and
Cleaning" section.
Carefully warm the leak-
ing sections of the door
seal with a hair dryer (not
hotter than approx. 50 °C).
At the same time shape the
warmed door seal by hand
such that it sits correctly.
The compressor starts after
a period of time.
39