Flexible Induction Cooking Area - Electrolux EHXP8565KK Benutzerinformation

12 www.electrolux.com
When you finish cooking and
deactivate the hob, the hood
fan may still operate for a
certain period of time. After
that time the system
deactivates the fan
automatically and prevents
you from accidental
activation of the fan for the
next 30 seconds.
Operating the fan speed manually
You can also operate the function
manually. To do that touch
hob is active. This deactivates automatic
operation of the function and allows you
to change the fan speed manually. When
you press
one. When you reach an intensive level

5. FLEXIBLE INDUCTION COOKING AREA

WARNING!
Refer to Safety chapters.
5.1 FlexiBridge function
The flexible induction cooking area
consists of four sections. The sections
can be combined into two cooking zones
with different size, or into one large
cooking area. You choose the
combination of the sections by choosing
the mode applicable to the size of the
cookware you want to use. There are
three modes: Standard (activated
automatically when you activate the
hob), Big Bridge and Max Bridge.
To set the heat setting use
two left side control bars.
Switching between the modes
To switch between the modes use
sensor field:
when the
you raise the fan speed by
.
and press again you will set fan
speed to 0 which deactivates the hood
fan. To start the fan again with fan speed
1 touch .
To activate automatic
operation of the function,
deactivate the hob and
activate it again.
Activating the light
You can set the hob to activate the light
automatically whenever you activate the
hob. To do so set the automatic mode to
H1 – H6.
The light on the hood
deactivates 2 minutes after
deactivating the hob.
When you switch between
the modes the heat setting is
set back to 0.
Diameter and position of the
cookware
Choose the mode applicable to the size
and the shape of the cookware. The
cookware should cover the selected area
as much as possible. Place the
cookware centrally on the selected area!
Place the cookware with the bottom
diameter smaller than 160 mm centrally
on a single section.