Operating Determinations - EuroLite AB-410X Alubar Bedienungsanleitung

Before taking into operation, every stand has to be checked upon possible damages.
If one part of a stand is defective, the stand must not be taken into operation.
Keep away children and amateurs!

3. OPERATING DETERMINATIONS

This device is a fundamental part for installing e.g. spotlights or lighting effects. This product is only allowed
to be operated with an alternating voltage of 230 V, 50 Hz and was designed for indoor use only.
This device is designed for mobile use via a lighting stand and for permanent installations via trussing
system.
This device is designed for professional use, e.g. on stages, in discotheques, theatres etc.
The maximum carrying capacity of this holding device must never be exceeded.
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
Make sure that the area below the installation place is blocked when rigging, derigging or servicing the
fixture.
When choosing the installation-spot, please make sure that the stand has to be installed in a way that no
person can enter the area below the stand or its load! Make sure that the respective area is blocked.
An unintended movement of the load has to be avoided.
Stands have to be operated by instructed persons. The different local conditions have to be considered in
terms of safety rules.
The installer is responsible for adhering to the carrying capacity given by the manufacturer, the safety
requirements and the qualification of possible co-workers.
When people are located below the load, all necessary safety measures have to be taken in order to avoid
injury.
The personell has to be instructed on the content of the user manual and on the dangers related with
operating stands.
Dependending upon the individual installation spot, all necessary measures against movement and for
securing the standing safety have to be created.
The installation is only allowed on carrying areas. In some cases, an appropriate substructure, e.g. via an
balancing foot, has to be created.
When choosing the installation material, optimum dimensions have to be chosen in order to secure
maximum safety.
Never install any objects offering a large surface for winds (e.g. banners, signs, etc.).
The loads have to be installed in a balanced way.
Operate the device only after having become familiar with its functions. Do not permit operation by persons
not qualified for operating the device. Most damages are the result of unprofessional operation!
Please use the original packaging if the device is to be transported.
13