Connecting The Cable - Korg RD-KB Bedienungsanleitung

RD-KB owner's manual

Connecting the cable

1
Connect one end of the included cable to the TO
RADIAS-R connector on the RD-KB, and connect
the other end to the TO KYBD connector located on
the RADIAS-R rear panel.
The included cable is solely for connecting the TO
RADIAS-R connector to the TO KYBD connector.
Do not connect it to any other connector.
2
Fasten the cable into the groove located on the left
side of the RADIAS-R.
Lowering the RADIAS-R
1
Grasp the handle with your left hand and lift up
the RADIAS-R; the arm lock will be released.
2
Make sure that the arm lock was released, and
gently lay down the RADIAS-R.
Do not grasp the tab while lowering the RADIAS-
R .
6
With the RADIAS-R down, press it further down-
ward until you hear a click; the RADIAS-R will be
locked to the RD-KB .
Attaching the accessory shelf
The RADIAS keyboard ( RD-KB ) includes an accessory
shelf that you may wish to install on your RADIAS. This
shelf provides a flat, compact platform where you can
position an effect processor, controller or other instru-
ment, such as a Korg KAOSS Pad, Korg padKONTROL,
or one of the Korg ElecTribes. If you chose to install the
accessory shelf, you will need to position the RADIAS-
R toward one end of the keyboard, rather than in the
center. The accessory shelf can be installed on either end
of the RADIAS' keyboard.
1
With the RADIAS-R folded down and locked to
the RD-KB, slide it to the right or left edge.
You can mount the accessory shelf in the space on
the opposite side.
If you want to change the position of the RADIAS-
R after assembly, you must lower the RADIAS-R
and lock it in place.