Care And Cleaning; Troubleshooting - Electrolux EHD60020X Benutzerinformation

24 electrolux
Hea Use to:
t
set-
ting
7 - 8 Heavy fry, hash browns, loin
steaks, steaks
9 Boil water, cook pasta, sear meat (goulash, pot roast), deep-fry chips
Boil large quantities of water. Power function is activated.

CARE AND CLEANING

Clean the appliance after each use.
Always use cookware with clean bottom.
Scratches or dark stains on the glass-
ceramic cause no effect on how the
appliance operates.
To remove the dirt:
1. – Remove immediately: melted plas-
tic, plastic foil, and food with sugar. If
not, the dirt can cause damage to
the appliance. Use a special scraper
for the glass . Put the scraper on the
glass surface at an acute angle and
move the blade on the surface .
– Remove after the appliance is
sufficiently cool: limescale rings ,
water rings, fat stains, shiny metallic
discolorations. Use a special cleaning
agent for glass ceramic or stainless
steel.

TROUBLESHOOTING

Problem
You cannot activate the appli-
ance or operate it.
An acoustic signal sounds and
the appliance deactivates.
An acoustic signal sounds
when the appliance is deactiva-
ted.
The appliance deactivates.
Time
5 - 15 min
2. Clean the appliance with a moist cloth
3. At the end rub the appliance dry
Possible cause
You touched 2 or more sensor
fields at the same time.
The STOP+GO function oper-
ates.
There is water or fat stains on
the control panel.
You put something on one or
more sensor fields.
You put something on the sen-
sor field .
Hints
Turn halfway through
and some detergent.
with a clean cloth.
Activate the appliance again
and set the heat setting in less
than 10 seconds.
Touch only one sensor field.
Refer to the chapter "Daily Use".
Clean the control panel.
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
Nominal
power con-
sumption
45 – 64 %
100 %
Remedy