m-e VDV-707 Betriebsanleitung Seite 18

VDV-707 | ENGLISH
Activating monitor / switching between additional cameras
Using the monitor button (2), you can monitor the entrance area at any
time without waiting for someone to press the bell push. Pressing the
monitor button a second time switches off the monitor.
NOTE: If an additional camera is connected (or multiple external units),
it can also be activated using the monitor button. Pressing the monitor
button once activates the camera of the external unit, pressing it a
second time switches to the first additional camera, and pressing it a
third time switches to the second additional camera. Once you flipped
through all the cameras the image from the first camera is shown again.
The monitor can only be switched off by pressing the voice button twice
or waiting approximately 60 seconds for the system to automatically
return to standby mode.
SETTINGS
Monitor settings (brightness, contrast, colour and mode)
The 7" monitor has an On Screen Display (OSD), which can be called
via the menu button (13) when the monitor is active. Each press of the
menu button highlights the next option in the OSD. The „+" and „-"
buttons (11 + 12) can be used to adjust the relevant values. If a button
GB
has not been pressed for 5 seconds, the OSD switches off automatically
and the set values are saved.
The following settings can be made:
Brightness
To adjust the brightness of the monitor to the local conditions, call
the menu via the menu button. Use the „+" button to increase the
brightness and the „-" button to decrease the brightness.
Contrast
To adjust the contrast of the monitor, call the OSD with the menu button
and press the menu button again. The „Contrast" item should now be
highlighted in the OSD and the contrast can be set via the „+" and „-"
buttons.
Saturation
To adjust the saturation of the monitor, call the OSD with the menu
button and press the menu button again twice. The „Saturation" item
should now be highlighted in the OSD and the saturation can be set via
the „+" and „-" buttons.
Audio
This menu item is not relevant for this system.
Reset
This item in the OSD can be used to reset the monitor to the factory
settings.
To reset the monitor, call the OSD with the menu button and press
the menu button again five times. The „Reset" item should now be
highlighted. Press the „+" button once to perform a reset. The OSD
immediately disappears and the factory settings are restored.
Exit
The OSD can be exited via this item. When „Exit" is highlighted in the
OSD, press the „+" button once to exit the OSD.
IMAGE MEMORY WITH TOUCH CONTROL
This monitor has an image memory that is controlled by touching the
capacitive touch display. If someone rings at the outdoor station, two
images are saved in the internal memory of the indoor station within
an interval of two seconds. Saving two images in short succession
ensures that visitors are recorded in such a way that they are clearly
recognisable.
The images can be deleted individually or all at once via the Settings
menu.
A maximum of 100 images can be saved, the memory cannot be
extended. If the door is rung when the memory is full, the two oldest
images will be overwritten. The images cannot be saved onto a PC or
similar. For data protection reasons, it is also not possible to record an
image manually.
Key
T1 = Settings
T2 = Image recording time
T3 = Image number
T4 = Number of images (max. 100)
T5 = Current time
T6 = Back button
T7 = Continue button
T8 = Back
T9 = Delete individual image
T10 = Set language
T11 = Set date/time
T12 = Delete all images
T13 = Display Quick Start Guide
T14 = Up arrow
18