Maintenance - Electrolux ERN 2320 Gebrauchsanweisungen

MAINTENANCE

Unplug the appliance before carrying out any
maintenance operation.
Warning
This appliance contains hydrocarbons in its
cooling unit; maintenance and rechanging must
therefore only be carried out by authorized
technicians.
Periodic cleaning
Clean the inside with warm water and bicarbonate of
soda.
Rinse and dry thoroughly.
Clean the condenser (black grill) and the
compressor at the back of the appliance with a
brush or a vacuum cleaner. This operation will
improve the performance of the appliance and save
electricity consumption.
Interior light
The light bulb inside the refrigerator compartment
can be reached as follows:
1. unscrew the light cover securing screw.
2. unhook the moving part as shown in the figure.
If the light does not come on when the door
is open, check that it is screwed into place
properly. If it still does not light up, change
the bulb.
The rating is shown on the light bulb
cover.
Defrosting
Frost is automatically eliminated from the evaporator
of the refrigerator compartment every time the motor
compressor stops, during normal use. The defrost
water drains out through a trough into a special
container at the back of the appliance, over the
motor compressor, where it evaporates.
It is important to periodically clean the defrost
water drain hole in the middle of the refrigerator
compartment channel to prevent the water
overflowing and dripping onto the food inside.
Use the special cleaner provided, which you will
find already inserted into the drain hole.
16
Periods of non-operation
When the appliance is not in use for long periods,
take the following precautions:
remove the plug from the wall socket;
remove all food;
defrost and clean the interior and all accessories;
leave the door ajar to allow air to circulate to prevent
unpleasant smells.
D411
D037
Montageanleitung fŸr den
integrierten Einbau
Nischenma§e
Hšhe (1) 1225mm
Tiefe (2) 550 mm
Breite (3) 560 mm
Zur Transportsicherung wurde die GerŠtetšr an
beiden Anschlagseiten mit Scharnierstiften befestigt.
Je nach TŸranschlag, Scharnierstift auf einer Seite
oben und unten entfernen.
Aus GrŸnden der Sicherheit mu§ eine
MindestbelŸftung gesichert sein, wie aus der
Abb.hervorgeht.
Achtung: Die Ventilations - ...ffnungen
mŸssenimmer saubergehalten werden.
Ferner ist auch am hinteren Einbauschrankteil ein
LŸftungskamin mit filgenden Massen notwendig:
Tiefe 50 mm
Breite 540 mm
GerŠt in die Nische einschieben bis die
Anschlagleiste (A) unten am Mšbel anliegt.
TŸr šffnen und GerŠt gegenŸber der Bandseite an
die Mšbelseitenwand anrŸcken. GerŠt mit den 4 bei-
liegenden Schrauben befestigen.
BelŸttungsgitter (C) und Scharnierabdeckung (D)
aufstecken.
min.
50 mm
200 cm 2
min.
200 cm 2
D567
3
1
2
PR01
A
D022
D
C
D727
9