Kenwood IM250 Bedienungsanleitungen Seite 4

Children should be supervised to ensure
l
that they do not play with the appliance.
Only use the appliance for its intended
l
domestic use. Kenwood will not accept
any liability if the appliance is subject to
improper use, or failure to comply with
these instructions.
before plugging in
Make sure your electricity supply
l
is the same as the one on the
underside of the power unit.
This appliance conforms to EC
l
Regulation 1935/2004 on materials
and articles intended to come into
contact with food.
before using for the first
time
1 Wash the parts: see 'cleaning'.
2 Twenty four hours in advance,
place the freezer bowl into a
freezer.
3 Prepare the ice cream or sorbet
mix (see recipe ideas). Allow the
mix to cool in the refrigerator.
key
a power unit release lever
b on/off switch
c power unit
d lid
e paddle
f freezer bowl
g outer bowl
to use your ice-cream
maker
1 Fit the power unit into the lid, it will
click into place.
2 Fit the paddle into the power unit.
3 Remove the freezer bowl from the
freezer and fit into the outer bowl.
4 Lower the assembled lid/power
unit/paddle onto the freezer bowl
and turn clockwise to lock into
position.
5 Switch on.
THE MACHINE MUST BE
l
SWITCHED ON BEFORE ADDING
THE ICE CREAM OR SORBET
RECIPE TO PREVENT THE MIX
FROM IMMEDIATELY FREEZING
ON THE INSIDE OF THE BOWL.
6 Use the chute and pour the ice-
cream or sorbet mix into the
freezer bowl.
When pouring mixture into the
l
bowl, always stop at least 2.5cm
from the top, as the mixture will
increase in volume during freezing.
7 Allow the mixture to churn until
frozen or the desired consistency
is reached, this can take up to 15
to 30 minutes, but most recipes
will be ready in less time.
Note: The paddle will stop
rotating when the mix is ready.
important
Do not stop and start the machine
l
during the freezing process, as the
mixture may freeze in contact with
the bowl and prevent movement of
the paddle.
In the unlikely event of the motor
l
overheating, a safety cut out will
operate causing the motor to stop.
If this happens, switch off, unplug
the machine and allow the power
unit to cool.
8 Switch off, remove the power unit/
lid by turning anti-clockwise. The
ice cream is ready to serve.
The ice cream produced should be
l
a soft spoonable type. This can be
transferred to a separate container
for storage in the freezer or if you
wish to firm the ice cream before
eating.
4