Technical Data; Installation - Küppersbusch IKE3270-2-2T Benutzerinformation

Problem
The temperature in the
appliance is too low.
The temperature in the
appliance is too high.
The temperature in the
refrigerator is too high.
The temperature in the
freezer is too high.
Upper or lower square is
shown in the tempera-
ture display.
dEMo appears on the
Display.

TECHNICAL DATA

Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in the
rating plate on the internal left side of the
appliance and in the energy label.

INSTALLATION

Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the
climate class indicated on the rating plate of
the appliance:
Possible cause
The temperature regulator is not
set correctly.
The temperature regulator is not
set correctly.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Products are too near to each
other.
An error has occurred in meas-
uring the temperature
The appliance is in demonstra-
tion mode (dEMo)
Height
Width
Depth
Set a higher temperature.
Set a lower temperature.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Store products so that there is
cold air circulation.
Call your service representative
(the cooling system will continue
to keep food products cold, but
temperature adjustment will not
be possible).
Keep pressed approximately 10
sec. the OK button since a long
sound of buzzer is heard and the
Display shut off for a short while:
appliance start works regularly.
1780 mm
560 mm
550 mm
21 h
230-240 V
50 Hz
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
29
Solution