Super Cooling; Water Dispenser; Dispensing Water - Siemens KS36WPI30 Gebrauchsanleitung

Super cooling

Super cooling sets the refrigerator
temperature to the coldest temperature
setting for approx. 15 hours. Then
the appliance automatically switches
to the temperature set prior to super
cooling mode.
Switch on super cooling mode, e.g.
before placing large quantities of food
■
in the refrigerator compartment.
for the fast cooling of drinks.
■
Note
When super cooling is switched on,
increased operating noises may occur.
Switching on and off
Fig. "
Press "super" button 2.
The button is lit when super cooling is
switched on.

Water dispenser

Cold water can be dispensed from
the appliance via the water dispenser.
When switching on, observe
the following
The water dispenser only works when
the appliance is connected to the water
mains.
When the appliance has been
connected, there are still air bubbles
in the lines.
Run off drinking water and pour away
until water can be dispensed without
bubbles. Pour away the first 10 glasses
(approx. 1.5 litre).
When the appliance has been installed
and switched on, temperature
differences may cause water to drip out
of the dispenser.
When the appliance has been switched
on, it may take several minutes until
water is dispensed.
Observing drinking water
quality
All materials used in the drinks
dispenser are odourless and tasteless.
If the water has an aftertaste, this may be
caused by:
Mineral and chlorine content
■
of the drinking water.
Material of the domestic water line
■
and connection line.
Freshness of the drinking water. If
■
water has not been dispensed for
a long time, the water may have
a "stale" taste. In this case fill approx.
10 glasses (approx. 1.5 litre) of water
and throw away.
We recommend that you regularly
dispense a little fresh water from
the water maker and that you do not
switch off the appliance. This will ensure
that the best water quality is retained.

Dispensing water

Fig. %
Keep pressing the button until
the required quantity is in the glass.
Dispensing is limited to a time of
30 seconds. Then the dispenser button
must be pressed again if required.
en
31