Connection With The Mains; Operation - EuroLite Snow 3010 Bedienungsanleitung

Before rigging make sure that the installation area can hold a minimum point load of 10 times the device's
weight.
For overhead use, always install a safety bond.
You must only use safety bonds and quick links complying with DIN 56927, shackles complying with DIN EN
1677-1 and BGV C1 carbines. The safety bonds, quick links, shackles and the carbines must be sufficiently
dimensioned and used correctly in accordance with the latest industrial safety regulations (e. g. BGV C1,
BGI 810-3).
Please note: for overhead rigging in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Pull the safety bond through the attachment eyelet and over the trussing system or a safe fixation spot.
Insert the end in the quick link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already hold the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting bracket and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!

Connection with the mains

Connect the device to the mains with the power plug. The occupation of the connection cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
Attention! The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a minimum
opening of 3 mm at every pole has to be included in the permanent electrical installation. The device must only be
connected with an electric installation carried out in compliance with the IEC standards. The electric installation must be
equipped with a Residual Current Device (RCD) with a maximum fault current of 30 mA

OPERATION

Press the button on the remote control to emit snow. At the same time the LEDs light up. With each press of
the button a different solid color or switching colors light up.
CAUTION: The escape nozzle will heat up during operation. Therefore do not touch the nozzle until it
has cooled down completely.
DANGER TO LIFE!
International
L
N
14/15
.
00095511.DOC, Version 1.1