Küppersbusch IKE2590-2-2T Benutzerinformation Seite 10

10
Problem
The appliance is noisy.
Power indicator light is flash-
ing.
The lamp does not work.
The compressor operates
continually.
There is too much frost and
ice.
The compressor does not
start immediately after press-
ing the , or after changing the
temperature.
Water flows on the rear plate
of the refrigerator.
Possible cause
The appliance is not suppor-
ted properly.
An error has occurred in
measuring the temperature.
The appliance is not working
properly.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incorrect-
ly.
Many food products to be
frozen were put in at the
same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed cor-
rectly.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not wrap-
ped properly.
Temperature is set incorrect-
ly.
This is normal, no error has
occurred.
During the automatic defrost-
ing process, frost melts on
the rear plate.
Solution
Check if the appliance stands
stable.
Contact a qualified electrician
or contact the nearest Au-
thorized Service Centre.
Contact a qualified electrician
or contact the nearest Au-
thorized Service Centre.
Close and open the door.
Refer to "Replacing the
lamp".
Refer to "Operation" chapter.
Wait some hours and then
check the temperature again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet-
ter.
Refer to "Operation" chapter.
The compressor starts after a
period of time.
This is correct.