Volume Unlock Set-Up; Querying The Stored 4-Digit Code; Resetting The Universal Remote Control - SAGEMCOM RCI88-320 Bedienungsanleitung

9.2 Volume Unlock Set-Up

When a TV ID is programed and the TV device becomes enabled, the Receiver Volume keys punch-
through to the TV device and transmit TV Volume codes also in Receiver-Mode. To control once again the
Receiver Volume press EXIT
blinks twice to indicate a successful set-up.
To return to control TV Volume also in Receiver Mode press TV
described. The device LED blinks twice to indicate a successful set-up.

9.3 Querying the stored 4-digit code

This procedure allows to visually 'retrieve' the 4-digit code stored on the remote control to control your TV
set.
1. On the remote control, press simultaneously the 1 and INFO
as the first number stored.
For example if the first digit is 9, the LED blinks 9 times. No blinking means the digit is 0 (zero).
2. Press simultaneously the 2 and INFO
3. Press simultaneously the 3 and INFO
4. Press simultaneously the 4 and INFO

9.4 Resetting the Universal Remote Control

1. On the remote control, press simultaneously the MENÜ
STANDBY
2. The remote control deletes all code stored. Once reset to its default factory settings, the LED blinks
twice again.
+ MUTE
for at least 3 seconds, until the LED blinks twice.
simultaneously for at least 3s. The device LED
keys: the LED blinks as many times
keys for the second digit.
keys for the third digit.
keys for the last digit.
70
+ MUTE as already
, TELETEXT and