Search For Additional Channels; Delete Additional Channels; Factory Reset - SAGEMCOM RCI88-320 Bedienungsanleitung

7.1.6 Delete Additional Channels

Use this feature to delete unwanted channels installed after you performed a manual channel search (see
Search for Additional Channels, page 39).
1. Press the MENÜ
2. Select SETTINGS with
3. Select SYSTEM UPDATE with
4. Select DELETE ADDITIONAL CHANNELS with
5. Select the channels to delete by highlighting them and press OK
check mark.
6. To unselect a channel, press OK
7. Once all the channels to delete are selected, press ZURÜCK
message appears.
8. Press OK

7.1.7 Factory Reset

This menu lets you restore the factory settings of the receiver.
Important
If you reset the default settings, you lose the favorite channels, settings and
bookings you made. This operation does not erase the recordings saved on the
receiver hard disk.
1. Press the MENÜ
2. Select SETTINGS with
3. Select SYSTEM UPDATE with
or the right
4. Select FACTORY RESET with
5. A warning message appears.
• To cancel the operation, select NO with
press OK
• To confirm the reset, select YES with
press OK
6. Once the default settings are restored, the receiver installation screen is displayed. You can then
reconfigure your receiver (see First installation, page 18).
key.
or , and press OK
or
. To scroll up or down the list, use the P
to confirm the deletion of the selected channels.
key.
or , and press OK
or
key.
or
, or press ZURÜCK
.
.
, and press OK or the right
or , and press OK
.
, and press OK
, and press OK .
or and
.
or , and
40
key.
or the right key.
: selected channels appear with a
-
+
or P key.
or the left key: a confirmation