Regular Cleaning; When The Refrigerator Is Not In Use; Trouble Shooting; How To Change The Bulb - Electrolux ERT 16002 W8 Benutzerinformation

56 electrolux
In case of increased demand e.g.
during heatwaves, the refrigerator
temporarily happens
constantly - during this the automatic
defrosting is ineffective.
Remaining small ice and frost stains on
back plate of the cooling compartment
after defrosting period is not abnormal.

Regular cleaning

It is recommended to wash the inside of
the refrigerator in 3-4 weeks time.
Household cleaner or soap must not be
used.
After you made it no-current wash the
appliance using lukewarm water and
wipe it.
Clean the magnet door rubber profile
with clean water.
After cleaning plug the appliance to the
mains socket.
Dust and dirt collected on the back of the
refrigerator, condenser is recommended
to be removed and clean the evaporative
tray on top of the compressor once or
twice a year.
When the refrigerator is not in
use
In case the appliance will not be used for
a long time follow these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up
of air inside.
GB
to operate

Trouble shooting

How to change the bulb

Should the light fail to work you can
change it as below:
Break the circuit of the appliance.
Unscrew the plate screw fixing the lamp
cover, then take the lamp cover off in the
direction of arrow and the bulb can be
changed. (Type of the bulb: Mignon 322,
230 V, 15 W, E 14 thread)
After changing bulb replace the lamp
cover, screw the plate screw and apply
voltage to the appliance.
The lack of light does not influence
operation of the refrigerator.