Electrolux ERT16002W8 Benutzerinformation Seite 17

3. Unscrew both adjustable feet.
4. Unscrew the screws of the door bottom hinge.
Remove the hinge. Put over the pin in the di-
rection of the arrow.
5. Unscrew and install the screw on the opposite
side.
6. Install the hinge on the opposite side.
7. Screw both adjustable feet.
8. Unscrew both screws on the rear side.
9. Push back the top and lift it from the fixing el-
ements.
10. Unscrew the screws of the door top hinge.
11. Remove the hinge. Put over the pin in the di-
rection of the arrow. Install the hinge on the
opposite side.
12. Tighten the hinge.
13. Put the top in position.
9) If foreseen
14. Pull it forward.
15. Screw both screws on the rear side.
16. Remove and install the handle
site side.
17. Reposition, level the appliance, wait for at least
four hours and then connect it to the power
socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter),
the gasket may not fit perfectly to the cabinet. In
that case, wait for the natural fitting of the gasket.
In case you do not want to carry out the above
mentioned operations, contact the nearest After
Sales Service Force. The After Sales Service spe-
cialist will carry out the reversibility of the doors at
your cost.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond to
your domestic power supply.
The appliance must be earthed. The power supply
cable plug is provided with a contact for this pur-
pose. If the domestic power supply socket is not
electrolux 17
9)
on the oppo-