Replacing The Lamp; Closing The Door - Electrolux ENKP2549AX Handbuch

Problem
The compressor
does not start im-
mediately after
pressing the Action
Freezebutton, or af-
ter changing the
temperature.
The temperature in
the appliance is too
low/high.
The temperature in
the wine cellar is too
high.
The temperature in
the freezer is too
high.
Upper or lower
square is shown in
the temperature Dis-
play.
dEMo appears on
the Display.

6.1 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service Cen-
ter.
Possible cause
This is normal, no error
has occurred.
Products prevent that wa-
ter flows into the water
collector.
The temperature regulator
is not set correctly.
The door is not closed
correctly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
An error has occurred in
measuring the tempera-
ture.
The appliance is in dem-
onstration mode (dEMo).

6.2 Closing the door

1.
2.
3.
Solution
The compressor starts after
a period of time.
Make sure that products do
not touch the rear plate.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the product tempera-
ture decrease to room tem-
perature before storage.
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Store products so that
there is cold air circulation.
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not be
possible).
Keep pressed approximate-
ly 10 sec. the OK button
since a long sound of buz-
zer is heard and the Display
shut off for a short while:
appliance start works regu-
larly.
Clean the door gaskets.
If necessary, adjust the door. Refer to
"Installation".
If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH 43