Setup; Power Supply; B) Peripheral Devices Connection - McCrypt MC-37 Bedienungsanleitung

4. Setup

A) Power supply
Using batteries
Observe correct polarity while inserting the batteries. Remove the batteries if the device
is not used for a long period of time to avoid damage through leakage. Leaking or damaged
batteries might cause acid burns when contact with skin, therefore use suitable protective
gloves to handle corrupted batteries.
Keep batteries out of reach of children. Do not leave the battery lying around, as there is
risk, which children or domestic pets could swallow it.
Replace all the batteries at the same time. Mixing old and new batteries in the device can
lead to battery leakage and device damage.
Make sure that batteries are not dismantled, short-circuited or thrown into fire. Never
recharge non-rechargeable batteries. There is a risk of explosion!
1. Open the battery compartment cover at the bottom of the keyboard.
2. Insert six Baby ("C" size) batteries while observing the correct
polarity (positive, "+" and negative, "-") embossed next to the battery
compartment.
3. Close the compartment cover, making sure it locks firmly in place.
Alkaline batteries are recommended. When the battery power becomes
low, the display will become dim.
Using optional power adapter
Never connect the keyboard to a power adapter immediately after it has been taken from a
cold place to a warm one. The condensed moisture can lead to malfunction or damage to the
keyboard or risk of electric shock.
Optional power adapter can be used as power source.
Connect the low voltage plug of the power adapter to the power receptacle of the keyboard. Once connected,
the keyboard will be powered by the power adapter and cut off the battery power supply.
The power adapter must match the following technical specification.
Input: 230V~/ 50Hz
Output: 9V=/ 200mA
Polarity:
Outer diameter of the plug: ø5.5 mm
Inner diameter of the plug: ø1.5 mm

B) Peripheral devices connection

Headphone
The keyboard's speakers are automatically shut off when a 3.5mm stereo plug is inserted into this jack.
The "PHONES/OUTPUT" jack also functions as an external output.
Connect the "PHONES/OUTPUT" jack to a keyboard amplifier, stereo system, mixer, tape recorder, or other
line-level audio device to send the instrument's output signal to that device.
Avoid listening with the headphones at high volume for long periods of time; doing so may not
only result in ear fatigue, it may be damaging to your hearing.
To prevent damage to the speakers, set the volume of the external devices at the minimum
setting before connecting them. Failure to observe these cautions may result in electric
shock or equipment damage.
Set the volumes of all devices at their minimum levels and gradually raise the volume controls
while playing the instrument to set the desired listening level.
Microphone
Only use monaural microphone.
Plug the 3.5mm plug of a microphone to "MIC IN" jack.
26
Annexe VI
Table des accords simples
C C#
Major (C)
Minor (Cm)
Seventh (C7)
Minor seventh
(Cm7)
F# G
Major (C)
Minor (Cm)
Seventh (C7)
Minor seventh
(Cm7)
D D# E
G# A A#
F
B
55