Practical Cooking Advice - Indesit KN6C61A/NL S Bedienungsanleitungen

GRATIN mode
The top heating element and the rotisserie (where
present) are activated and the fan begins to
operate. This combination of features increases the
effectiveness of the unidirectional thermal radiation
provided by the heating elements through forced
circulation of the air throughout the oven. This helps
prevent food from burning on the surface and allows
the heat to penetrate right into the food.
! The GRILL and GRATIN cooking modes must be
performed with the oven door shut.
Spit roast (only available in certain models)
To operate the spit roast function (see diagram) proceed as
follows:
panel of the oven.
3. Start the rotisserie using the knob to select MODE
or .
! When the mode is activated, the spit will stop if
the door is opened.
1. Place the dripping
pan in position 1.
2. Place the rotisserie
support in position 3 and
insert the spit in the hole
provided on the back

Practical cooking advice

! Do not place racks in position 1 or 5 during fan-
assisted cooking. Excessive direct heat can burn
temperature sensitive foods.
MULTILEVEL
• Use positions 2 and 4, placing the food which
requires more heat on the rack in position 2.
• Place the dripping pan on the bottom and the rack
on top.
GRILL
• When using the GRILL cooking mode, place the
rack in position 5 and the dripping pan in position
1 to collect cooking residues (fat and/or grease).
When using the GRATIN cooking mode, place
the rack in position 2 or 3 and the dripping pan in
position 1 to collect cooking residues.
• We recommend that the power level is set to
maximum. The top heating element is regulated by a
thermostat and may not always operate constantly.
PIZZA OVEN
• Use a light aluminium pizza pan. Place it on the rack
provided.
For a crispy crust, do not use the dripping pan as
it prevents the crust from forming by extending the
total cooking time.
• If the pizza has a lot of toppings, we recommend
adding the mozzarella cheese on top of the pizza
halfway through the cooking process.
Timer
To activate the Timer proceed as follows:
1. Turn the TIMER knob in a clockwise direction  for
almost one complete revolution to set the buzzer.
2. Turn the TIMER knob in an anticlockwise direction 
to set the desired length of time.
GB
21