Sharp AR-122E N Bedienungsanleitung Seite 60

4
Press the start (
The selected application launches and scanning begins.
• If the following screen appears, select Button
• If step 4 is performed with the "Show TWAIN setting screen when
Opening the scanner driver and scanning from your computer
Follow the steps below to open the scanner driver setup screen. As an example, this
instruction is given using Sharpdesk as an image capture application.
• Scanning is not possible during a copy and print job.
• The method for starting the scanner driver differs depending on the
• When using the scanner driver to scan an original that has been
Using the SHARP TWAIN
1
Place the original you wish to scan on the original table/SPF.
For the procedure for placing the original, see "ORIGINAL PLACEMENT"
(p.16).
2
After starting Sharpdesk, click the
"File" menu and select "Select
Scanner".
58
Manager and click "OK". Button Manager starts and
the application associated with Button Manager
starts. If you want only Button Manager to start in
this case, set up Button Manager for use in
Windows as explained in "Setting up the Button
Manager" (p.53).
scanning" checkbox selected in the Scan Parameter Setting Dialog
Box (p.55), the TWAIN settings screen will automatically appear.
Check the settings, and then press the start (
the "Scan" button in the TWAIN setting screen to start scanning. The
scanned data will be transferred to the application.
type of application. Refer to the manual or the help file of your
application.
placed in the SPF. If you perform a pre-scan (see the online manual or
the help file for the scanner driver), the original in the SPF will be
output to the exit area after scanning. To scan the original after the
pre-scan, place the original in the SPF once again.
) key.
) key again or click
Click here