Changing The Display Mode While Listening To An Fm Station; Setting The Ta Volume Level; Automatic Clock Adjustment - JVC KD-LX555R Bedienungsanleitung

Changing the display mode while
listening to an FM station
You can change the initial indication on the
display to either station name (PS NAME) or to
station frequency (FREQUENCY), while listening
to an FM RDS station.
• See also "Changing the general settings
(PSM)" on page 31.
1
Press and hold SEL (S) for more than 2
seconds so that one of the PSM items appears
on the display.
¢ or 4
2
Press
DISP (display)."
3
Turn the control dial to set to the desired
indication ("PS NAME" or "FREQUENCY").
4
Press SEL (S) to finish the setting.
Note:
By pressing DISP (D), you can change the display
while listening to an FM RDS station.
Each time you press the button, the following
information appears on the display:
Station name
Station frequency
(FREQUENCY)
Programme type
• Then, the display goes back to the original
indication in several seconds.
to select "TUNER
(PS NAME)
(PTY)

Setting the TA volume level

You can preset the volume level for TA Standby
Reception. When a traffic programme is
received, the volume level automatically changes
to the preset level.
• See also "Changing the general settings
(PSM)" on page 31.
1
Press and hold SEL (S) for more than 2
seconds so that one of the PSM items appears
on the display.
¢ or 4
2
Press
(volume)."
3
Turn the control dial to set to the desired
volume.
You can set it from "TA VOL 00" to "TA VOL
50."
4
Press SEL (S) to finish the setting.

Automatic clock adjustment

When shipped from the factory, the clock built in
this unit is set to be readjusted automatically
using the CT (Clock Time) data in the RDS
signal.
If you do not want to use automatic clock
adjustment, follow the procedure below.
• See also "Changing the general settings
(PSM)" on page 31.
1
Press and hold SEL (S) for more than 2
seconds so that one of the PSM items appears
on the display.
¢ or 4
2
Press
(adjustment)."
3
Turn the control dial to select "ADJUST OFF."
Now automatic clock adjustment is canceled.
4
Press SEL (S) to finish the setting.
To reactivate clock adjustment, repeat the same
procedure and select "ADJUST ON" in step
Note:
You must stay tuned to the same station for more than
2 minutes after setting "AUTO ADJ" to "ADJUST
ON." Otherwise, the clock time will not be adjusted.
(This is because the unit takes up to 2 minutes to
capture the CT data in the RDS signal.)
to select "TA VOL
to select "AUTO ADJ
3
.
17