Electrical Connection - Constructa Cd939550 Gebrauchs- Und Montageanleitung

E
LECTRICAL CONNECTION
Before connecting the appliance to the
    
power supply, always follow the instructions
and warnings in the chapter entitled "Safety
instructions"!
The extractor hood may only be connected
    
by a qualied electrician who is familiar with
the regulations of the relevant electricity
supply company.

RISK OF INJURY
If the power cord of the extractor hood is
damaged, it must be replaced by the
manufacturer, his customer service or a
similarly qualied person to prevent hazardous
situations.
The extractor hood may be connected to a
    
correctly installed earthed socket only.
Attach the earthed socket as directly as
    
possible behind the ue duct.
– The earthed socket should be connected via
its own circuit.
– If the earthed socket is no longer accessible
following installation of the extractor hood,
a disconnector must be tted as for a
permanent connection.
Installation instructions
If a permanent connection is required
A disconnector must be provided on the
    
installation side. Switches with a contact
opening of more than 3 mm and all-pole
disconnection are regarded as disconnectors.
This includes LS switches, fuses and contactors.
Electrical specications
The required connection data can be found on
the rating plate inside the appliance when the
grease lters have been removed.
Length of the power cord: approx. 1.30 m.
This extractor hood complies with the EC
interference suppression regulations.
27