Vibration And Noise Reduction; Behaviour In Emergency Situations; Residual Risks - Parkside Pssap 20-Li C3 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

11) Hold the power tool tightly with
both hands while working and
ensure a secure footing. The power
tool is guided more securely with both hands.
12) Secure the workpiece. A workpiece
that is retained with clamping products or
a vice is held more securely than with your
hand.
13) Wait until the power tool has
stopped before placing it down. The
accessory tool can tilt and lead to loss of
control over the power tool.
14) Do not saw any materials (e.g. lead-based
paints and coatings or materials containing
asbestos) whose dust can be harmful.
˜ Vibration and noise reduction
To reduce the impact of noise and vibration
emission, limit the time of operation, use low-
vibration and low-noise operating modes as well
as wear personal protective equipment.
Take the following points into account to minimise
the vibration and noise exposure risks:
Only use the product as intended by its
design and these instructions.
Ensure that the product is in good condition
and well maintained.
Use correct accessory tools for the product
and ensure they are in good condition.
Keep tight grip on the handles / grip surface.
Maintain this product in accordance with
these instructions and keep it well lubricated
(where appropriate).
Plan your work schedule to spread any high
vibration tool use across a longer period of
time.
˜ Behaviour in emergency
situations
Familiarise yourself with the use of this product by
means of this instruction manual. Memorise the
safety warnings and follow them to the letter. This
will help to prevent risks and hazards.
Always be alert when using this product, so
that you can recognise and handle risks early.
Fast intervention can prevent serious injury
and damage to property.
Switch the product off and disconnect it from
the mains if there are malfunctions. Have the
product checked by a qualified professional
and repaired, if necessary, before you
operate it again.
˜ Residual risks
Even if you are operating this product in
accordance with all the safety requirements,
potential risks of injury and damage remain. The
following dangers can arise in connection with the
structure and design of this product:
Health defects resulting from vibration
emission if the product is being used over
long periods of time or not adequately
managed and properly maintained.
GB/CY 15