Connecting The Appliance To The Power Supply - Progress Pm2761 Benutzerhandbuch

80 Progress
Connecting the appliance to the
power supply
(A)
• The electrical outlet should be readily
accessible so that the unit can be
unplugged easily in an emergency.
Or it should be possible to isolate the
oven from the supply by incorporating a
switch in the fixed wiring in accordance
with the wiring rules.
• The socket should not be positioned
behind the cupboard.
• The best position is above the cupboard,
see (A).
• Connect the appliance to a single phase
230 V/50 Hz alternating current via a
correctly installed earth socket. The
socket must be fused with a 10 A fuse.
• The power supply cord may only be
replaced by an electrician.
• If the supply cord is damaged it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in
order to avoid a hazard.
• Before installing, tie a piece of string to
the power supply cord to facilitate
connection to point (A) when the
appliance is being installed.
• When inserting the appliance into the
high-sided cupboard, DO NOT crush the
power supply cord.
• Do not immerse the power supply cord
or plug in water or any other liquid. Do
not allow the power supply cord to run
over any hot or sharp surfaces, such as
the hot air vent area at the top rear of the
oven.