Health Hazard; Operating Determinations - EuroLite LED IP BCO-1 Bedienungsanleitung

Important:
Damages caused by the disregard of this user manual are not subject to warranty. The dealer
will not accept liability for any resulting defects or problems.
Please make sure that there are no obvious transport damages. Should you notice any damages on the
power unit or on the casing, do not take the device into operation and immediately consult your local dealer.
This device falls under protection-class III. The device must be operated with an appropriate power unit.
Always plug in the power unit last.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it
on immediately. The arising condensation water might damage your device. Leave the device switched off
until it has reached room temperature.
Never look directly into the light source, as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!
Keep away children and amateurs!

OPERATING DETERMINATIONS

This device is a LED lighting effect for creating decorative effects. This product is only allowed to be operated
with a supply voltage of 6 V DC and is also qualified for outdoor use.
This device is splash-proof (IP X4) and therefore qualified for indoor and outdoor use. In order to maintain
this protection grade after opening the housing, any rubber sealings must be examined for damages and
always be correctly installed.
For outdoor use, the installer must always make sure to connect a rubber cable H05RN-F or HO5RR-F. For
installations in the ground, an underground power cable NYY must be used!
All valid instructions concerning the installation of cables outdoors or in the ground must be adhered!
The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The maximum relative humidity is 100 % with an ambient temperature of 25° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
Lighting effects are not designed for permanent operation. Consistent operation breaks will ensure that the
device will serve you for a long time without defects.
The device must never be installed over areas, where persons may be seated or walk by.
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
When using smoke machines, make sure that the device is never exposed to the direct smoke jet and is
installed in a distance of 0.5 meters between smoke machine and device. The room must only be saturated
with an amount of smoke that the visibility will always be more than 10 meters.
Never use the device during thunderstorms. Over voltage could destroy the device. Always disconnect the
device during thunderstorms.

HEALTH HAZARD!

9/12 00091587, Version 1.0