Qwic RD10 Bedienungsanleitung Seite 61

System settings
Set the time
When the clock is displayed, press and hold the
' ' button for 2 seconds to adjust the time. Use
the ' ' and ' ' button to adjust the time and press
the ' ' button to confirm.
Reset the trip information
Reset the trip information by selecting any trip info in
the information field and holding the '
for 2 seconds.
Automatic light switch
Press and hold the '
activate or deactivate the automatic light function.
When activated, the light sensor will notice when it gets
dark and will activate the lights.
Change unit setting (km/h - mph)
Turn off the display by pressing the '
briefly. Then push and hold both the '
and the ' ' button for at least 3 seconds until the
software version appears on the display screen. The unit
settings have now been changed. Repeat these steps to
change the unit setting back.
' button
' button for 2 seconds to
' button
' button
Display & Controls: Mid-drive motor models
Other system settings such as the tire size can only be
adjusted by connecting the system to a computer. Your
dealer can do this for you.
Error codes
Your bike has been equipped with a self-diagnosis tool
to find possible problems early. In case an error has
been reported by the system an error code will be
displayed in the information field in the bottom. An
often occuring problem with e-bike systems is a low
battery, which can be indicated by the following error
codes:
Code 10, 12 or 24
Check if the battery is properly charged.
It is possible that other errors are detected in the
system, or that the above instructions do not help.
In this case, please contact your dealer.
61