Meanings Of Symbols; Safe Operation - Hitachi Koki CG – PSB Serie Bedienungsanleitung

MEANINGS OF SYMBOLS

NOTE: Some units do not carry them.
Symbols
WARNING
The following show symbols used for the machine. Be sure that you understand their meaning before use.
Pole Saw
It is important that you read, fully understand
and observe the following safety precautions
and warnings. Careless or improper use of the
unit may cause serious or fatal injury.
Read, understand and follow all warnings and
instructions in this manual and on the unit.
Always wear eye, head and ear protectors
when using this unit.
Keep all children, bystanders and helpers
15 m away from the unit. If anyone approaches
you, stop the engine and cutting attachment
immediately.
Chain oil tank capacity
Dry weight
(Without guide bar and chain)
kg
Guide bar length
÷ 2
Chain pitch
Chain gauge
Type of chain
Depth gauge setting
NOTE: Equivalent noise level / vibration level are calculated as the time-weighted energy total for noise / vibration levels
under various working conditions with the following time distribution:
* 1/2 Idle, 1/2 racing.
INTRODUCTION
It is important that you read and understand your HITACHI
brush cutter owner's manual as well as this manual.
Please carefully review and observe all safety precautions
and warnings.
Careless or improper use of the unit may cause serious or
fatal injuries.
This pole trimmer attachment has been designed for certain
HITACHI brush cutters.
(Original instructions)
Side plate fi ling angle
Top plate angle
File guide angle
File
Depth gauge
Gloves should be worn when necessary, e.g.,
when assembling cutting equipment.
Use anti-slip and sturdy footwear.
L
Sound pressure level LpA by ISO 22868
pA, eq
Equivalent*
ISO22868
L
Sound power level LwA by ISO 22868
WA
Racing
ISO22868
Vibration level by ISO 22867
a
hv, eq(F)
Front or Left handle / Equivalent*
Vibration level by ISO 22867
a
hv, eq(R)
Rear or Right handle / Equivalent*
K
Uncertainty

SAFE OPERATION

All overhead electrical conductors and communications
wires can have electricity fl ow with high voltages.
Never touch wires directly or indirectly when trimming,
otherwise serious injury or death may result.
○ Review the area to be trimmed. Look for hazards that
could contribute to unsafe conditions. DO NOT operate
unit if any wires (power, telephone, cable, etc.) are
closer than 15 m (50 ft) to any part of the operator or unit.
(Fig. 1)
5
WARNING DANGER
English