Technical Data - NUK Baby Menu Bedienungsanleitung

Problem
Steaming or blending
does not work
Bowl leaking
Steam escaping from
the edge of the bowl
lid (steam inlet) during
steam cooking
Jerky or noisy
operation
The steam cooking
indicator extinguishes
after activation
Ingredients are not
mixed correctly.
5

TECHNICAL DATA

Power supply:
Operating humidity:
Protection class:
Degree of protection:
Power rating:
Heat output:
Possible cause
Bowl lid not correctly
positioned.
Device not connected to
the power supply.
No blade fitted.
Seal incorrectly applied.
Seal is porous or
damaged.
Bowl damaged.
Bowl lid not correctly
applied.
Hot steam duct blocked.
Lid deformed.
Steam outlet on base
unit is deformed.
The cover for the hot
steam duct is not fitted.
Blade is not correctly
fitted.
Bowl is not correctly
seated.
No water was filled into
the water tank.
Blade is blunt.
Blade is not correctly
fitted.
220 - 240 V 50 Hz
20% - 95% relative humidity
I
IPX0
200 W (motor)
500 W
42
Solution
Ensure that the lid is correctly fitted
to the bowl and the latter correctly
fitted to the base unit.
Connect the plug to the wall socket.
Install a blade as described in
section 2.2.1.
Apply the seal to the blade with the
suction lip at the bottom (section
2.2.1).
Use the spare seal.
You require a new bowl. Contact
your relevant dealer (section 3.3).
Apply the lid to the bowl so that the
latter is fully sealed.
Clean the hot steam duct (section
3.1)
You require a new lid. Contact your
relevant dealer (section 3.3)
Contact your relevant dealer (section
3.3)
Fit the cover to the underside of the
lid.
Install the blade as described in
section 2.2.1.
Check that the bowl and lid are
correctly fitted and locked in place.
Allow the device to cool and add the
required level of water.
You require a new blade. Contact
your relevant dealer (section 3.3)
Install the blade as described in
section 2.2.1.