Cleanmaxx Pro DMW007 Gebrauchsanleitung Seite 20

EN
level, one or both indicator lights (9)
light up.
• Spraying (Picture D: 1.): Press the
spray button (16) on the handle (17)
and moisten the surface to be cleaned.
• Scrubbing (Picture D: 2.): Use the
attachment and gentle pressure to scrub
the surface to be cleaned.
• Suction (Picture D: 3.): Pull the nozzle
opening with gentle pressure over the
surface to be cleaned. The liquid is
collected in the dirty water tank (6).
• When the fresh water tank is empty or
the dirty water tank is full, switch off
the device. Only after this should you
fill or empty the appropriate tank (see
the "Cleaning the Device" chapter).
Place the nozzle on a cloth as
residual water may escape after
it has been switched off.
After Use
1. Empty the fresh water tank and reinsert
it.
2. Switch on the device again and press
the spray button to remove excess
water from the device.
3. Switch off the device.
4. After every use, fully empty and clean
the tanks (see the "Cleaning the Device"
chapter).
Cleaning the Device
Please Note!
■ Make sure that no liquid gets into the
motor unit.
■ Do not use any sharp or abrasive clean­
ing agents or cleaning pads. These may
damage the surfaces.
20
30077_DE-EN_A5_V2.indb 20 30077_DE-EN_A5_V2.indb 20
Suction Hose with Handle
Rinse the suction hose with handle regularly
to remove residues of the cleaning agent:
1. Remove the nozzle (see the "Attaching
and Detaching Accessories" chapter).
2. Pour clear water into a vessel and suck
up the water from the vessel (see the
"Use" chapter).
3. Plug the handle with its opening onto
the handle cleaning tool (24) on the
device (Picture F) and push the spray
button (16).
4. Pull the handle off the handle cleaning
tool.
Clean / Dirty Water Tank
1. Remove the tanks (1, 6) (see the
" Attaching and Detaching Accessories"
chapter) and empty them completely.
2. Thoroughly rinse the tanks and the lids
with clear water.
3. Allow to air dry before reinserting.
Nozzles
1. Remove hair and fluff from the
attachments.
2. Detach the attachment and the cover
of the wide nozzle (19) (Picture E).
3. The nozzles (19, 22), the attachments
(20, 21) and the cover can be rinsed
with clear water.
4. Allow all parts to dry in the air.
Motor unit
• If necessary, wipe down the housing
with a damp soft cloth. Then dry with
a cloth.
• Filters (26, 27) and seals: Regularly
remove coarse dirt and, if necessary,
wipe the seals with a damp cloth.
29.01.2026 16:18:40 29.01.2026 16:18:40